Bridging SmartRG 505n/516ac modems

Here are the instruction for bridging the SmartRG modem 

1- Log into the firmware of the modem (192.168.1.1) 

2- Once there, click on the Advanced section. It will ask you for credentials in which case you’ll enter admin as both username and password. 

3- Once logged in, click on the WAN service under the Advanced setup section, check all Interfaces listed, and click on the remove button. 

4- Next click on the WAN service section, then click on Add. The first option to choose here would be the atm0(0_0_35) (Eastern Locations)or atm1(0_0_33) (Western location) interface in the dropdown for speed of 7 or 16mbps and click on next. 

5- It will request some additional information. Make sure to select Bridging, -1 for Priority and -1 for VLAN, click on Next, then next once again, then Apply/Save. 

6- Click on add once again, except this time, select the ptm0(0_1_1) Service, then click on next. 

7- It will request some additional information. Make sure to select Bridging, 1 for Priority and 35 for VLAN, click on Next, then next once again, then Apply/Save.